Calibration Solution packet for the
TDS-1 TesterHanna TDS Calibration Instructions
HI 70033 Conductivity Solution
To calibrate your Hanna TDS instrument, please use the following instructions:
1) Check the temperature in the room where you're doing your instrument calibration.
2) Find the closest corresponding temperature on the chart on the front of your packet of conductivity solution.
3) Next, divide the number next to that temperature in half and use that number to set your TDS.
For example, if your room temperature is 72 degrees F., then the calibration number will be 79 divided 2, which equals 39.5. Your instrument should be set as close to 39.5 as possible. Now you can go to your instruction sheet included with your TDS1 meter and proceed.
One time use only.
This product was added to our catalog on Friday 01 February, 2008.
